* CDR-1100 (250-1092) CD-ROM Device Driver

This driver enables the user to use the CDR-1100 CD-ROM Drive with
an IBM PC, XT, AT, or compatible computer. Please note that the
computer must have a TANDY BIOS ROM version 01.03.01 or later and
TANDY MS-DOS version 3.30.00 or later.


This disk contains the following files--

   DD250.SYS     DD250XT.SYS   LICENSE.TXT   MSCDEX.EXE
   MSCDEX.TXT    SETUP.EXE     TCDP.EXE      USRGUIDE.TXT
   README.TXT


In order to obtain a printout of this README.TXT file, insert this
disk in Drive A, make sure your printer is switched on, is on line,
and at the C:\> prompt, type the following command--

   PRINT A:README.TXT

and press <Enter>.


INSTALLATION

1.  Follow the procedure described in the chapters titled
    HARDWARE INSTALLATION, PREPARING THE ADAPTER INTERFACE CARD,
    INSTALLING THE ADAPTER INTERFACE CARD, and CONNECTING DATA AND
    POWER CABLES in the Installation Guide in order to install
    the CD-ROM Drive.

2.  Start up your computer. Make sure that the C:\> prompt is displayed
    on the screen.

3.  Insert this disk in Drive A.

4.  Type

       A:

    and press <Enter>. The A:\> prompt should be displayed on the screen.

5.  Type

       SETUP

    and press <Enter>.

6.  Respond accordingly to the screen prompts.

    NOTE:
       *Select the default settings by pressing <Enter>. To change the
        default response (due to changes made on the adapter interface
        card), type in your choice at the prompt.

7.  Remove this disk from the drive and reboot the computer.



NOTE:
"While reasonable efforts have been taken in the preparation of this
information to assure its accuracy, Tandy Corporation/Radio Shack
assumes no liability resulting from the use of the information
contained herein."
