/*=============================================================================
   FILE:         Install.txt
-------------------------------------------------------------------------------
   DESCRIPTION:  ActiveRadio ISA 
                 Windows 200 driver installation notes
-------------------------------------------------------------------------------
   COPYRIGHT:    (c) 2001, TerraTec Electronic GmbH. All Rights Reserved.

                 Information in this file is the intellectual property of
                 TerraTec Electronic GmbH, and contains trade secrets
                 that must be stored and viewed confidentially.
                 By viewing, using, modifying and compiling 
                 the programming code below you acknowledge you have read,
                 accepted and executed the Software licensing agreement 
                 your company has established with TerraTec Electronic GmbH.
=============================================================================*/

 After mounting the card and restart of Windows 2000
 Windows 2000 will detect new hardware "ActiveRadio".
 When you are prompted for the driver path 
 enter the path where this file is located.
 
 Windows 2000 will install the driver and prompt you to reboot.

 Usually after rebooting the ActiveRadio hardware should be properly configured !!!

 Please open now the device manager and show the "Audio, video and game controller"
 tree. If everything worked fine you should see an entry "TerraTec ActiveRadio ISA".


 ATTENTION: In some cases the automatic PnP configuration fails.
 If the entry "TerraTec ActiveRadio ISA" in the device manager tree 
 shows a yellow exclamation mark the ActiveRadio is probably not properly activated.

 There are two ways to activate the card.


-------------------------------------------------------------------------------
   1) BIOS
-------------------------------------------------------------------------------

	In most BIOSes you have an option "PnP BIOS installed" or similar. 
	If this settings is set to TRUE	please change it to FALSE.

	The card should now be activated by the BIOS directly after booting.


-------------------------------------------------------------------------------
   2) Manual confguration
-------------------------------------------------------------------------------

	Go to the Device Manager, right click on "TerraTec ActiveRadio ISA" 
	and select "Properties".
	On the page "Resources" click on the button "Manual configuration".

	Remove the check on "Automatic configuration". 
	Windows will now always use the resources that are shown in the list above.

	After a re-boot the card should be activated and the driver properly loaded.





