Enhanced VGA DRIVER INSTALLATION
                FOR MICROSOFT WINDOWS 3.0 and 3.0a

The instructions which follow are applicable to users of Microsoft
Windows and Enhanced VGA card (based on Tseng ET4000 chips).
Note that, to use 800x600 , 1024x768 and 1280x1024 modes, an ANALOG
color display capable of these high resolutions is required.

The "Enhanced VGA - Windows 3.0 Driver" diskette contains 256-color
and high-resolution drivers, as well as a file called SETUP.INF
that replaces the file of the same name on the Microsoft Windows
3.0 or 3.0a Setup "DISK 1" diskette. Follow the instructions listed
below carefully to install the drivers.

Instructions:

1. Make a DISKCOPY of the Setup "Disk 1" diskette.
   Example (for systems with a single floppy and hard drive):

         C:>DISKCOPY A: A:

   The system will use drive A: for both the original and the
   copy as the source and target diskettes are inserted
   alternately for the copy.

2. After the copy is made, return the original to its jacket and
   store safely.

3. Copy the SETUP file from the "Enhanced VGA - Windows 3.0 Driver"
   diskette to the newly-created copy of the Setup "Disk 1"
   diskette. Example (for systems with a single floppy and hard
   drive):

   For Windows 3.0:
         C:>COPY A:SETUP.W30 B:SETUP.INF

   For Windows 3.0a:
         C:>COPY A:SETUP.W3A B:SETUP.INF

   The system will use drive A: as drive B: also. After the copy
   is finished, type A: [ENTER].

4. Type SETUP [ENTER] to begin installation of Windows.

5. Review the configuration list when it is shown. If you wish to
   change Display type, move the cursor (highlighted line) to the
   "Display:" line and press [ENTER] to select from the available
   list.

6. The program will ask you to insert the "Enhanced VGA - Windows
   3.0 Driver" diskette in order to install the drivers as required.
   After  this is done,  the installation program  will continue
   normally.

After you complete the above steps you can begin using Windows.

Note: If you wish to change the display type after completing the 
installation, click on the Windows Setup icon found in the Main 
desktop window.