                        Additional Information

                 Gateway 2000 Windows NT Driver V0.10


    Installation of Windows NT Driver
    =================================

    Under Windows NT's control panel, select "drivers" icon and choose
    <Remove> to unload any "Wave/Midi", "MIDI Synthesizer" or "Low level
    Wave, MIDI and AUX support" drivers (if there are existed) from the
    installed drivers menu.

    The Windows NT drivers can be installed using one of the following 
    methods:

    Automatic Installation
    ======================

    1.  At Windows NT command prompt, insert the Windows NT Device Driver
        Installation disk into the drive (A: or B:).  Run the installation 
        program by typing "SETUP" at the A:\ prompt and pressing the <Enter>
        key.  Follow the on-screen instructions to complete in the driver
        installation.

    2.  Restart the Windows NT to take effect of the new driver. 


    or,

    
    Manual Installation
    ===================

    1.  Under Windows NT's control panel, select "drivers" icon and choose 
        <Remove> to unload any  "Wave/Midi", "MIDI Synthesizer" or "Low level
        Wave,MIDI and AUX support" drivers (if there are existed) from the 
        installed drivers menu.

    2.  Restart Windows NT and select the "drivers" icon again under Control 
        Panel.

    3.  Select the "Unlisted & Updated Driver" option under <Add> option.
        Click on <Browse> button to specify the NT's driver source (i.e.A:\
        or B:\).

    4.  Select <ADD> to load in the following three drivers into the System.

        Low level Wave, MIDI & AUX support
        AZI MIDI Synthesizer
        16-bit Wave/MIDI/Aux

    5.  Restart the Windows to take effect of the new NT drivers.



              ------------  The End  -------------

