STANDARD MICROSYSTEMS CORPORATION

                       EISA Configuration File
          For Ether 10/100 Fast Ethernet EISA Adapters

                         INSTALLATION GUIDE

   This software is licensed by SMC for use by its customers only.
        Copyright (c) 1995 Standard Microsystems Corporation.
                         All rights reserved.


This installation guide describes:

o  How to use EZStart to copy the EISA configuration files from
   the SuperDisk to your PC.

o  The EISA configuration file for configuring an EISA 
   bus-compatible computer for use with SMC Ether 10/100 Fast 
   Ethernet EISA Adapters


NOTE: Ensure that the line speed (10 Mbps vs. 100 Mbps) configured
      for the adapter matches the speed of the hub to which it is
      attached. It is important to set the adapter at the correct 
      line speed (10/100 Mbps) using the EISA Configuration Utility. 
      Refer to pages 3-3 and A-9 in the Ether 10/100 user guide for
      further details. Refer also to the section in the EISA configuration 
      file !SMCA010.CFG (provided on this SuperDisk) titled 
      "FUNCTION="Line speed selection".


COPYING SUPERDISK FILES

From the EZStart Driver Installation screen, select 'Copy Files'
to copy all the files from the SuperDisk to the Destination
Directory recommended by EZStart, or to a different directory
that you specify.


COPYING THE EISA CONFIGURATION FILE (!SMCA010.CFG)

The EISA configuration file (!SMCA010.CFG) is located in the
root directory of the SuperDisk. You can use this file in one
of three ways:

1. When prompted by your EISA Configuration Utility for this file,
   you can insert the SuperDisk and specify the path as A:\.

2. You can copy !SMCA010.CFG using EZStart to the same directory
   where your EISA Configuration Utility (ECU) is located
   (e.g. C:\ECU). Your ECU should default to this path when searching
   for the file, but if not, when prompted by your ECU for this file,
   you can specify the appropriate path (e.g. C:\ECU). 

3. If you have used EZStart to copy all SuperDisk files to a
   directory on your computer's hard disk, and you are running EZStart
   from the hard disk and not from the SuperDisk (floppy drive),
   you can use EZStart to copy the EISA configuration file to
   A:\ to create an installation diskette. When prompted by your
   ECU for this file, you can insert the installation diskette and 
   specify the path as A:\.


EISA CONFIGURATION FILE

   !SMCA010.CFG        For SMC Ether 10/100 Fast Ethernet 
                       EISA Adapters.

To configure your computer, follow the instructions provided in your 
PC's User Guide.


This commercial computer software and documentation is provided 
with RESTRICTED RIGHTS.  Use, duplication, or disclosure by the
Government is subject to restrictions set forth in subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer Software
clause at DFARS 252.227-7013, or subparagraphs (c) (1) and (2) of 
the Commercial Computer Software -- Restricted Rights clause at
FAR 52.227-19, or Alternate III of the Rights in Data -- General
clause at FAR 52.227-14, as applicable.  The manufacturer /
subcontractor is Standard Microsystems Corporation,   80 Arkay Drive,
Hauppauge, NY  11788. 

SMC and Standard Microsystems are registered trademarks; and 
Ether 10/100, EZStart, and SuperDisk are trademarks of Standard 
Microsystems Corporation. Other products and company names are 
registered trademarks or trademarks of their respective companies.