*************************************************************
*    Installation for Windows for Workgroups 3.11 Driver    *
*************************************************************

   1. Insert the driver disk into drive A: or B:.

   2. To install NDIS drivers under Windows for Workgroups 3.11
      (WFW311), user should be in the WFW311 environment first and choose
      the Network Setup icon.

   3. Click "Drivers" in the Network Setup window.

   4. Choose the "Add Adapter..." item under Network Drivers.

   5. When the new menu is displayed, choose the "Unlisted or Updated Network
      Adapter" item for the new driver. Then, click the OK button.

   6. There is a box for entering the drive and directory. Please key
      in "A:\WFW311" or "B:\WFW311" plus <enter>. The "Unlisted or
      Updated Network Adapter" will show the names of adapters. Select the
      "CNet CN935 PCI Bus NDIS 2.0.1 Driver" or the "CNet CN935 PCI Bus
      NDIS 3.0 Driver". Then, click the OK button.

   7. User can choose the "Setup..." button to change the SIA mode, Slot
      Number, or Data Rate when choose NDIS 2.0.1 driver and the Burst
      Length, Connection Type, Pci Mechanism, Receive Buffers, or Snooze
      Mode when pick NDIS 3.0 driver up.  If user choose NDIS 2.0.1 driver,
      the Slot Number should be greater than or equal to 16.  If a user has
      two network adapters on board and NDIS 2.0.1 driver has been selected,
      the slot number of the first adapter should be 16 and the second one is
      17.  Next, push the set button for saving driver configurations. The
      other option is Data Rate which user must choose the 10 Mbps for
      transmission.  The connection type of NDIS 3.0 parameter has Auto
      Sense, 100Mbps, 100Mbps Full_Duplex, 10Mbps, or 10Mbps Full_Duplex
      selection. In this adapter, user should avoid to choose 100Mbps items.

   8. Go back to the Network Drivers window and confirm the driver is
      correctly installed. To close the window, click the OK button.

   9. Exit the Network Setup, after making sure the correct driver and
      protocols have been selected.

  10. Next, there are two boxes which appear on screen in order. The WFW311
      will automatically modify the CONFIG.SYS, AUTOEXEC.BAT, PROTOCOL.INI,
      and SYSTEM.INI files

  11. Reboot.

  Remark : if users install NDIS 2.0.1 driver for real mode and the DOS
           version is not 6.22 or above, please unload the EMM386.EXE in
           the CONFIG.SYS file.