====================================================
=     CN100TX(B) PCI-BUS FAST ETHERNET ADAPTER     =
=     Driver Installation Procedure                =
= >>> Windows for Workgroups 3.11                   =
====================================================

The Windows for Workgroups 3.11 driver files are in the \WFW311 subdirectory 
of this diskette.

 1. Start WfW311. From the Main Menu double-click on the Network Setup icon.

 2. In the Network Setup window double-click on "Drivers".

 3.. Under Network Drivers, choose the "Add Adapter..." item.

 4. Insert this CN100TX(B) driver diskette into a floppy disk drive (this 
    example uses Drive A:).

 5. When the new menu shows up, choose the "Unlisted or Updated Network
    Adapter" item for the new driver. Then, click the OK button.

 6. There is a box to enter the drive and directory. Please key
    in "A:\WFW311" or "B:\WFW311" plus <enter>. The "Unlisted or
    Updated Network Adapter" will show the names of adapters. Select the
    "NDIS 2.0.1 Driver" or the "NDIS 3.0 Driver".
    Then, click the OK button.

 7. Users can choose the "Setup..." button to change the SIA mode, slot
    number, or data rate when choose NDIS 2.0.1 driver and the burst length,
    bus number, connection type, or pci mechanism when pick NDIS 3.0 driver
    up.  If user choose NDIS 2.0.1 driver, the slot number should be greater
    than or equal to 16.  If users have two 100TX network adapters on board
    and NDIS 2.0.1 driver has been selected, the slot number of the first
    adapter should be 16 and the second one is 17. Next, push the set button
    to save driver configurations. The other option is Data Rate which
    user could choose the 10 or 100 Mbps for transmission.  The connection
    type of NDIS 3.0 parameter has Auto Sense, 100Mbps, 100Mbps Full_Duplex,
    10Mbps, or 10Mbps Full_Duplex selection.

 8. Go back to the Network Drivers window and confirm the driver is correctly
    installed. To close the window, click the OK button.

 9. Exit the Network Setup, after making sure the correct driver and
    protocols have been selected.

10. Next, there are two boxes showing up on screen in order. The WFW311
    will automatically modify the CONFIG.SYS, AUTOEXEC.BAT, PROTOCOL.INI,
    and SYSTEM.INI files

11. Reboot.

**NOTE: Before installing NDIS 2.0.1 driver for real mode, please unload
        the EMM386.EXE in the CONFIG.SYS file.
###