********************************************************************** * LAN ADAPTER Series -- Setup/Diagnostic Program V120 * ********************************************************************** Date: 10/19/1994 A. OVERVIEW =========== The SETUP.EXE Program is used to configure and verify the correct configuration and operation of an LAN ADAPTER series LAN adapter before installing the network software. B. BEFORE STARTING THE PROGRAM ============================== 1. After turning off the PC's power, insert the adapter into the PC. 2. Boot the PC to a DOS prompt. ** Memory resident (TSR) programs and device drivers should not be loaded while the Diagnostic Program is active, so you may need to temporarily rename your CONFIG.SYS and AUTOEXEC.BAT files. The Diagnostic Program is always run without loading any network software. C. STARTING THE PROGRAM ======================= The LAN ADAPTER 2000J series support Jumperless mode. The adapter configuration could be used in Jumperlss mode only. 1. In the DOS prompt, type SETUP to run Setup/Diagnostic Program, like as below: A:>SETUP 2. Configuration: Configuration - To look at the configuration currently contained in the LAN adapter. The setup program will detect and reconfigure IRQ and I/O that confict. Select Configuration to setup hardware configurations that you want, such as I/O, IRQ, BootROM usage. Exit 3. Diagnostic Select Diagnostic to get into configuration testing. Diagnostic - Test to see if the adapter's function is correct and To verify the adapter transceiver is ok. Exit D. SUPPORT ========== If you have any additional questions regarding your Setup/Diagnostic Program, contact your dealer or distributor's technical support department. ======================================================================