   Configuring many adapters with the same settings
                                                                    v2.00
      
      To use the identical configuration on multiple adapters, save the
      configuration of one adapter and load the saved configuration file
      onto another adapter.
      
      When you do this, you're only saving or loading the hardware
      configuration. To complete the installation, you must install the
      network drivers on each computer.
      
      
      To save the configuration
      =========================
      
      1  Insert the Configuration disk into a drive, and switch to that
         drive.
      
      2  Type:   NPROSET /SAVE=filename
      
         For example:  NPROSET /SAVE=A:\NPROCONF.CFG
      
         Or, you can type NPROSET and select SAVE/LOAD CONFIGURATION TO
         FILE then SAVE CONFIGURATION TO FILE. NProSet asks you to
         specify where to save the file.
      
      
      To load a saved configuration onto an adapter
      =============================================
      
      1  Put the adapter in the computer according the instructions on
         page 3 of the Installation Guide.
      
      2  Copy the configuration file you want to use onto the computer or
         onto a floppy disk.
      
      3  Insert the Configuration disk into a drive, switch to that
         drive, and type:
         
         NPROSET /LOAD=filename
      
         For example:
         
         NPROSET /LOAD=A:\NPROCONF.CFG
      
         Or, you can type NPROSET and select SAVE/LOAD CONFIGURATION
         FROM FILE then LOAD CONFIGURATION FROM FILE. NProSet asks you
         to specify the location of the configuration file you want to
         use.
      
      Hints and Tips
      
      ==============
      
      1  To load a configuration file without launching NProSet, at the
         command line, substitute "NPROSET" with the module "ISS2" for
         NodeRunner Pro(TM) adapters.
      
         For example:
         
         ISS2 /LOAD=A:NPROCONF.CFG
      
      2  Different versions of NProSet use different file formats to
         save the configuration file.  If NProSet doesn't recognize the
         configuration file, rebuild the configuration file with the
         version of NProSet you are currently using.
      
      3  If you are receiving a message that NProSet can't load the
         configuration onto the adapter you have, and you have verified
         the version of NProSet as mentioned in step 2 above, then you
         may be trying to load a configuration that was saved for a
         different type of the NodeRunner Pro adapter.
      
         To verify your configuration file matches the adapter you're
         trying to configure:
         
         -  make sure that the adapter has the same number of network
            connectors, and
         
         -  make sure that the "82595FX version" numbers match by running
            NProSet and selecting VIEW ADAPTER CONFIGURATION.
      
      
