
        Catalyst's RGLister v1.02
        written by:  Justin Day

        RGLister is replacement for the normal Renegade 10-05 file
        listing routine.  It supports 17 extra lines of description,
        for a total of 23 lines.  I wrote it when I was finally fed up
        with the normal 5 lines, and I didn't like the annoying pauses
        and flagging problems associated with description extenders.

        In addition to the increase in description size RGLister allows
        the user to use a simple light-bar interface.


        There are 5 basic commands to RGLister:  Next, Flag, Info, Help
        and Quit.  You can use these commands in two ways:

                1)  Use the arrow keys to highlight the command
                    you wish to use and press ENTER.

                2)  Press the first letter of the command.



        Here is a quick review of the commands:


           [N]ext  -  Show the next page of files.

           [B]ack  -  Show the previous page of files.
           
           [F]lag  -  Flag file(s)

                      Flagging files is very simple.. Just move the
                      light-bar to the file you wish to flag.  You
                      may use the arrow keys or A and Z if you're
                      terminal doesn't support the arrows.  Once you
                      have the file you wish to flag highlighted
                      hit the space bar.  

                      Flagged files are shown in red.  They may be
                      un-flagged by simply highlighting the file(s)
                      and pressing the space-bar.

                      Once you've completed your flagging press ENTER.

                      NOTE:  The files are not actually put into the
                      Renegade batch queue until you exit RGLister.
                      RGLister does not check to see if you have enough
                      credits or ratio to download a file, so you will
                      not know until you exit RGLister.
           
           [I]nfo  -  Show Extended Information on a file.

                      To see information on a file simply highlight the
                      file you want more information on, using the arrows 
                      or A and Z, and press ENTER.
                      
           [H]elp  -  You're looking at it.

           [Q]uit  -  Quits RGLister and puts files in the batch queue
                      if any.



