
                        Procomm Plus Issues

    Procomm Plus 2.0 has bugs.  PCP 1.xx is OK as is PCP 2.01 or
higher.  The Init string for PCP is AT&F&C1&D2^M

CTS/RTS=ON   Autobaud detect=OFF     drop DTR to hangup=YES

modem speed 19,200, (38,400 or 57,600)

    In the dialing directory press P and you can enter any of the
following......


                 V.32 / V.42bis Dialing Prefixes

     The  normal dial Prefix is ATDT. If the number  is  423-1563
then  it sends ATDT4231563 to the modem, which then  dials,   and
connects. This is using auto-speed (baud) negotiation as well  as
negotiating   Protocol (V.42bis, MNP etc.). Some  modems/software
you   will  call  do NOT like this.  Listed  are  alternate  dial
Prefixes you may use.

AT&Q5N1DT           :negotiates SPEED and Protocol (default) 1
AT&Q6N1DT           :negotiates SPEED only 1
AT&Q5S37=11N0DT     :*Connect 14400, negotiate Protocol 1 2
AT&Q6S37=11N0DT     :*Connect 14400 only 2
AT&Q5S37=9N0DT      :*Connect 9600, negotiate Protocol 1
AT&Q6S37=9N0DT      :*Connect 9600 only 1
AT&Q5S37=6N0DT      :Connect 2400, negotiate Protocol 1
AT&Q6S37=6N0DT      :Connect 2400 only 1
AT&Q5S37=5N0DT      :Connect 1200, negotiate Protocol 1
AT&Q6S37=5N0DT      :Connect 1200 only 1
AT&Q5S37=1N0DT      :Connect 300, negotiate Protocol 1
AT&Q6S37=1N0DT      :Connect 300 only 1
                     * for all V.32 modems
                     1-for error correcting modems
                     2-for V.32bis modems

              Connect result messages / modem speed

    S95=44 gives you full result messages with CONNECT (modem to
computer speed).  If you need CONNECT (modem to modem) speed the
same as CARRIER (modem to modem) use S95=45.  When running a BBS,
try S95=3 and you will get only CONNECT(carrier) message, with \ARQ
for error correcting modems.  Always set your 'speed' in your
program to the highest permissable computer - to - modem speed
(check your manual).  The V.32xx or V.42bis modem will take care of
modem to modem speed.
