HP JetStore 6000   

This file contains instructions in the following sections
for installing the HP JetStore 6000   :

- A. Installing the HP JetStore 6000    Under IBM OS/2 v2.x
- B. Installing the HP JetStore 6000    Under IBM OS/2 v1.3

A. Installing the HP JetStore 6000    Under IBM OS/2 v2.x:
   In order for Sytos Premium to access this backup device, the
   following three lines must appear in CONFIG.SYS:

          BASEDEV=[ADD-name].ADD
          BASEDEV=OS2SCSI.DMD
          DEVICE=[drive:]\[path]\SYFILES\HPS_J60H.SYS
   
   Where [ADD-name].ADD is the appropriate Adapter Device
   Driver for your host adapter.  Refer to the Sytos Premium
   README for the list of ADDs currently supported with
   this release of Sytos Premium.

   You must remove any REM (if it exists) from the third
   line shown here.  Note that [drive:]\[path] represents
   the drive and directory where the Sytos Premium files were
   installed and should already be displayed in your
   CONFIG.SYS.  

   Also note that [ADD-name].ADD and OS2SCSI.DMD are the
   names of the IBM OS/2 v2.x device drivers.  If the
   BASDEV= statements do not appear in CONFIG.SYS, refer to
   the OS/2 v2.x documentation for installation
   instructions.

   After changing your CONFIG.SYS file, you need to shutdown
   and reboot your system for these changes to take effect.

B. Installing the HP JetStore 6000    Under IBM OS/2 v1.3:
   In order for Sytos Premium to access this backup device, the
   following two lines must appear in CONFIG.SYS:

          DEVICE=C:\OS2\SCSI.SYS /N:4
          DEVICE=[drive:]\[path]\SYFILES\HPS_J60H.SYS

   You must remove any REM (if it exists) from the second
   line.  Make sure that these two lines are in the order
   shown.

   Note that [drive:]\[path] represents the drive and
   directory where the Sytos Premium files were installed and
   should already be displayed within these statements.  
  
   Also note that SCSI.SYS is the name of the IBM SCSI
   Device Driver. If the DEVICE=C:\OS2\SCSI.SYS /N:4
   statement does not appear in CONFIG.SYS, you will need to
   add it as follows:

     1. Insert your copy of the Sytos Premium Install diskette.
     2. At the prompt enter DDINSTAL.
     3. Be sure to select the SCSI Device Driver.
     4. Check CONFIG.SYS so that the two device driver lines
        appear in the order shown:
          DEVICE=C:\OS2\SCSI.SYS /N:4
          DEVICE=[drive:]\[path]\SYFILES\HPS_J60H.SYS
     5. Check also that there is no REM on the line
        containing HPS_J60H.SYS.
     6. Reboot your system.

   Note that after changing your CONFIG.SYS file, you need
   to reboot for these changes to take effect.
