
popmail <subcommands>

    popmail addserver <host> [<seconds>] [hh:mm-hh:mm] <protocol>
    <mailbox> <username> [<password>]


     Add hostP as a pop server. When seconds is given, a timer is
     started to query the  host with that interval for mail. If not
     specified no querying to the pop host will be started. You have
     to do that manualy with a kick.  When  hh:mm is given then only
     in that exact timeframe are queries to the host made (allowed).
     Protocol is either POP2 or POP3, depending on the  mail service
     the host is providing.

     Note: pop2 is superceded by pop3.

     Mailbox is the mailbox name on the host where mail has to be
     picked up.
     
     Username and password are this system's validation parameters for
     the host.  If password is omitted, it is obtained from the console.

     Note: On entering this command the host name is looked up. If
     nonexistent, an error message is displayed.

    popmail dropserver <host>


     Drops host from the list of pop servers to be queried.  All
     references to the entry are deleted from the current system.

    popmail kick <host>

     Starts a pop session with host to retrieve mail.  This command is
     needed  when no interval is specified with the popmail addserver
     command.

    popmail list

     Lists the current popmail server table.

    popmail quiet <yes|NO>

     Displays or sets the notification of new mail ariving via pop.

    popmail trace <level>                                 Default: 1

     Displays or sets the trace level of pop sessions. Current trace
     levels are:
     
      0 - No tracing
      1 - Serious errors reported
      2 - Transient errors reported
      3 - session progress reported
     
     Note that tracing only goes to the log file.

    popmail lzw [off | ON]

     Displays or sets the LZW compression enable flag.
