
If you have difficulty running the Defect Control System Demo:

            1 - Run the Demonstration Program from DOS before
                entering Windows.

                The DCS Demonstration program is a "slide show"
                type presentation.  The demonstration driver
                program is DOS based.  Running the demo program
                outside of Windows will give you more DOS
                conventional memory.  475 Kbytes of conventional
                memory are needed.  You can determine the amount
                of conventional memory available by typing "mem"
                at the DOS command prompt.  You can unload TSR's,
                network software, and device drivers to make more
                conventional memory available.
                
            2 - Unload any TSR's or drivers.
            
                If you have enough conventional memory but are
                still unable to run the demonstration program,
                then the most likely cause of the problem is a
                conflict with a TSR or device driver.  The
                vdetect virus detection program and the
                dfimouse mouse driver are known to cause
                problems.
                
            3 - Call The Software Edge Technical Support Line
            
                If you are still unable to run or install the
                demonstration program, please give us a call
                at 719/598-3787.
            
=============================================================

Instructions for Defect Control System Demonstration Program

Hardware and Software Requirements

            To use the Defect Control System Demonstration
            program, your computer must meet the following
            requirements:
            
              VGA display
              4 Megabytes of free disk space.
              475 Kbytes of conventional DOS memory

Using the Windows Setup Program

            1.Start the Microsoft Windows operating
              environment.
            2.If you are installing from a floppy disk,
              insert the disk labeled Demonstration Disk
              into the drive and close the door.
            3.From the Program Manager Window, choose the
              Run command from the File menu.
            4.Type the path for the setup program.  For
              example, if the setup program is on a floppy
              disk in drive a, type a:\setup.
            5.Follow the instructions on the screen.
            
            If you have difficulty installing or running the
              demonstration program, please see
            the README file on the installation disk.

Using the DOS Setup Program

            1.If you are installing from a floppy disk,
              insert the disk labeled Demonstration Disk
              into the drive and close the door.
            2.From the DOS command line type the path of
              the dossetup program along with the source
              drive and the destination drive.  For
              example, if the dossetup program is on drive
              a, and you wish to install the demo to drive
              c, type a:\dossetup a: c:.
            3.Follow the instructions on the screen.
            
            If you have difficulty installing or running the
              demonstration program, please see
            the README file on the installation disk.

To Un-Install if you used the Windows Setup Program

            1.Remove the directory and contents which you
              specified to the Windows setup program.
            2.Remove the DCS Demo program manager group.

To Un-Install if you used the DOS Setup Program

            1.Remove the directory \edgedemo from the drive
              you specified to the dossetup program.
