ST80D v1.3 for Model I (CMD) - Lance Micklus (1979)

                _______________________________
                ST80D CONTROL AND COMMAND CODES


          CONTROL                            COMMAND

G = (BEL)  Bell                      B = Auto line feed on
H = (BS)   Rub out                   C = Receive buffer on
I = (HT)   Tab                       D = Auto line feed off
J = (LF)   Line Feed                 E = Exit ST80D
K = (VT)   CRLF                      F = Dump buffer to disk
L = (FF)   Home cursor & CLS         G = Dump disk to buffer
M = (CR)   Return                    I = Reset RS232 switches
N = (SO)   Cursor on                 L = Enable lower case
O = (SI)   Cursor off                M = Transmit auto logon
P = (DLE)  Delete                    O = Transmit buffer
Q = (DC1)                            P = Line printer on
R = (DC2)                            R = CMD "R"
S = (DC3)                            S = Line printer off
T = (DC4)                            T = CMD "T"
X = (CAN)  Backspace                 U = Upper case lock
Y = (EM)   Advance                   X = Receive buffer off
Z = (SUB)  Cursor up one line        Z = Zero clock
0 = (ETB)  Send large print
1 = (ESC)  Escape
2 = (FS)   Home cursor
3 = (GS)
4 = (RS)   Clear to end of line
5 = (US)   Clear to end of frame
8 = Left bracket
9 = Right bracket
Left Arrow = Delete (DEL)


BREAK          Press BREAK key
ESCAPE         Hit CLEAR key then any letter (for graphics)
CONTROL        Hold up-arrow while pressing control key
REPEAT         Hold right-arrow while pressing any key
COMMAND        Hold shift up-arrow while pressing command key
TOGGLE KYBD    Hit shift down-arrow


Speed of automatic transmission may be altered by using up and down arrows.
