WARM00/CMD will give a warm start for Basic 01.00.00 if you accidentally reset  or Basic dumps you back into DOS.   WARM02/CMD does the same for Basic 01.01.02.You also need an overlay, WARM/OVL, whhich you make as follows:-

In DOS, type LOAD BASIC/CMD.
When it is loaded type DUMP WARM/OVL (START=X'4000',END=X'43FF')<ENTER>

Now if you are suddenly back in DOS type WARM<ENTER> and you will be back in    Basic with the program and variables intact.   It is just as well to save the   program and do a proper reset and re-enter Basic, although I have continued to  run programs quite satisfactorily.   When you first re-enter Basic you may get  an OUT OF MEMORY message on your first command.   If you do simply re-enter it, and it will be OK.

README/TXT  M.C.Matthews 04.05.91
