
                                  COPY WIZARD

        Copy Wizard is a data transfer program that will allow you to
        transfer all the data from DOS 3.3 or higher drives, up to and
        including Windows '95.   That's right now you can transfer Windows
        '95 with long file names and system registry still intact, through
        DOS.

	It is recommended that you run Copy Wizard from a bootable Floppy.

How To Make A Copy Wizard Boot Disk

	***To make Copy Wizard bootable, simply boot your computer to a C:
        prompt.  From the prompt type SYS A:.  When it is done it will
        say system transferred.  Now your disk is bootable.

	***Copy Wizard also requires that himem.sys be loaded.  If you are
        running Windows '95 then follow the below instructions:

	From the C: prompt type CD\WINDOWS Now you should see C:>WINDOWS.
        Now type COPY HIMEM.SYS A:.  When it is done it will say one file
        copied.

	***If you are running a DOS based machine then use the following
        instructions:

        From the C: prompt type CD\DOS.  Now you should see C:>DOS.  Now
        type COPY HIMEM.SYS A:.  When it is done it will say one file
        copied.

	***Copy a MOUSE DRIVER (mouse.com) on to the floppy and all of the
	Copy Wizard files.

        Now you can rename the config.cw to config.sys and the autoexec.cw
        to autoexec.bat.

	Your Floppy should contain: Bootable System Files, Himem.sys,
	Mouse Driver, Autoexec.bat, Config.sys, and Copy Wizard Files.

How To Use Copy Wizard

        When Copy Wizard loads it will show you a table that has the infor-
        mation on each drive in the system.

        Choose the drive you wish to transfer from.  Copy Wizard will now
        index the selected drive.  When it is done you will see a directory
        structure on the left.  In the middle box it will show you the files
        that are listed in the directory that is highlighted.

        If you wish to change the current source drive click on the the first
        icon on the bottom left.  To select the destination drive click on 
	the secound icon from the left.  This will index the destination
	drive in the third box.  Click on the directory you wish to send the
	information to.  If the drive is empty or you wish to send it to the
	root directory just leave the "\" highlighted.

        To mark the entire drive click on the drive icon with the big green
        check mark on it.  If you wish to unmark a directory highlight the
        directory and use the right mouse button to unmark the information.
        (If the directory is already unmarked then the information will
        become marked.)

        If a directory is in white then that is the directory that is high-
        lighted. (This doesn't mean it's marked, it just shows the current 
	directory.  A red directory means the whole directory is marked.
	A purple directory shows that only some of the files in that
	directory are marked, and if the directory is black then nothing is
	marked.

	Once you have chosen the source and destination drives and the data
	is selected, click on the paper with wheels to begin the transfer.

If you have any questions please call Tech Support at:

                              770-925-4420

For a manual with screen grabs please see the manual.doc file.  It is in
MS-Word 7.0 format.


