@DefineDisk

	@Label = "DISK 5 OF 12"

   @If ('H' [= @Group)

       @BeginLib DCADHELP.RED

           @File   *.*     @Out    @OutDrive:\@Subdir\HELP\*.*

       @EndLib

   @EndIf

   @If ( 'D' [= @Group )

       @BeginLib DRV1.RED

			@File   *.*	    @Out    @OutDrive:\@Subdir\DRV\*.*
			@File   VESACHK.EXE @Out    @OutDrive:\@Subdir\*.*

       @EndLib

   @Endif

@EndDisk      

@If ( 'E' [= @Group )

   @Chain ("DISK 6 OF 12")

@ElseIf ( 'E' [= @Group )

   @Chain ("DISK 7 OF 12")

@ElseIf ( 'V' [= @Group )

   @Chain ("DISK 8 OF 12")

@EndIf

@Finish

   @Cls

	@ChDrive@OutDrive
        @ChDir "@Subdir"

        @If (('A'[=@Group) || ('D'[= @Group ))
           @Mkdir ("@OutDrive:\\@Subdir\\LYR")
           @Mkdir ("@OutDrive:\\@Subdir\\PLT")
           @Mkdir ("@OutDrive:\\@Subdir\\SYM")
           @Mkdir ("@OutDrive:\\@Subdir\\TPL")
        @EndIf


   @If (1004 [= @Option)
        The DataCAD Configuration Utility will now be run.  This is
        where you should select your display device, digitizer (if any),
        plotter, etc.

	@pause

      @If (@Spawn ("CONFIG"))
      @EndIf

   @EndIf
   @Cls

        The installation has been successfully completed.
        To run DataCAD, type RUNDCAD at the DOS prompt and
        press <Enter>.

	Note:  Please be sure you have installed your mouse
	       manufacturer's supplied driver according to
	       their instructions prior to running DataCAD.

	Thank-you for choosing DataCAD!

	@pause
@EndFinish
