
                         1. Processor version
                         ====================

	This version demands 286 or higher processor. Call to your dealer
to get 8086 version.

                         2. Desktop publishing
                         =====================

    TrueType fonts' installation
    ----------------------------
Disk PROGRAM2 contains now TrueType scalable fonts for desktop
publishing. They are not copied on your hard disk by CA-SETUP program.
Use Windows 3.1 Control Panel/Fonts to install them.

CA 1.3 manual contains information about Windows fonts' installation
procedure. Note that DIAGRAM fonts (both screen and printer) are
now replaced with TrueType fonts: ISDiagram for high resolution printers
and ISDiagramLR for small size diagrams or low resolution printers.

    New entry in RTF.INI
    --------------------
New entry was added to RTF.INI to solve compatibility problems:

Section:         General
Entry:           Destination
Possible values: AMIPro (or AMI), PageMaker (or PM), WinWord (or WW)
Note:            This entry was added to solve minor RTF incompatibility
                 problems found when using RTF with AMIPro 3.0.
                 If you are using MS Word for Windows, set this entry to
                 "WinWord". If you are using Aldus PageMaker, set it to
                 "PageMaker". If you are using Lotus AMIPro, set it to
                 "AMIPro".

    Note for Aldus PageMaker users
    ------------------------------
When importing RTF files generated by Chess Assistant,
	i)  Uncheck "Convert quotes" check box in file selection dialog box.
	ii) You need to redefine style for diagram bodies. Go to style
        definiton dialog box, choose style for diagram body, and go to
        paragraph formatting and here to spacing dialog box. Here you
        should set "Autoleading" to 100%

    Note for Windows HP LaserJet 4/4M users
    ---------------------------------------
There are some errors in HP printer drivers for LaserJet 4/4M (version 31.1.03
as written in About box) that sometimes prevent chess symbols and diagrams 
from being printed correctly.
There are two possible solutions:
	i)  In Control panel/Printers/Setup/Options set Graphics mode to
        Raster and check Print TrueType as Graphics check box. This will
        cost you up to 5-6 minutes per page on 386DX/40 and 4MB RAM;
	ii) or choose printer driver for HP LaserJet III/IIIp. This will
        cost you 600 dpi resolution found in HP LaserJet 4/4M.

                       3. Changes in Chess Assistant
                       =============================

1. You can now print contents of board file on current printer. To
   achieve this press F8 function key in Load Position dialog box.
2. You can now exit Tree window with subset also by pressing F9 key in
   Tree window.
3. New operation is available in tree mode. Pressing F6 is now equivalent
   of the following sequence of operations:
       i)   Save current tree position and current move side.
       ii)  Exit tree and make current subset equal to the whole base (F6).
       iii) Enter tree mode for this new subset with previously saved
            position and move side.
   Previous function of F6 function key in Tree mode was reassigned to F7
   function key.
4. You can press "->" key in List Mode for quick view current game notation.
