			FULL SHIELD SHLDRSTR PROGRAM
				Version 1.0

This file is being read because you have had a problem during the Full
Shield Installation.  If you did not have any problem after rebooting 
the system, disregard this readme file.
 
There are two things that should have happened after rebooting the 
system after installing Full Shield:
 
	1) A password box should have appeared.
 
	2) After you correctly entered the Access Password, which was
	   initialized during installation, your system should have
	   booted as it normally does.
 
If one or both of these instances did not occur, then proceed with the 
SHLDRSTR program on this diskette.
 
Run the SHLDRSTR program from drive A: (or B:).  It will ask you to enter 
your Access Password which was initialized during installation. After the 
Access Password has been correctly entered, the SHLDRSTR program will 
restore your system and reboot.  

After rebooting, contact Micah Development technical support. Please be 
seated next to your computer with the following information: 
 
	1)  The Full Shield version number 
	2)  The contents of your AUTOEXEC.BAT and CONFIG.SYS files
	3)  Your computer name, type, and processor
	4)  The version of DOS you are using
	5)  The brand, model, and size of hard drives in your computer
	6)  The hard disk partitions and sizes
	7)  The names and version numbers of other RAM resident programs
	    you are currently using 
 
