This information is for VisualGen Developer PTF2.
 
These are the instructions to create the 11 diskettes that comprise
VisualGen Developer PTF2.
 
You should now have the following files in a subdirectory which were downloaded
in binary.
 
 DEV10INS.DSK    --  This is Visualgen Developer PTF2 Install disk
 
 DEV10DK1.DSK    --  This is Visualgen Developer PTF2 disk 1
 DEV10DK2.DSK    --  This is Visualgen Developer PTF2 disk 2
 DEV10DK3.DSK    --  This is Visualgen Developer PTF2 disk 3
 DEV10DK4.DSK    --  This is Visualgen Developer PTF2 disk 4
 DEV10DK5.DSK    --  This is Visualgen Developer PTF2 disk 5
 DEV10DK6.DSK    --  This is Visualgen Developer PTF2 disk 6
 DEV10DK7.DSK    --  This is Visualgen Developer PTF2 disk 7
 DEV10DK8.DSK    --  This is Visualgen Developer PTF2 disk 8
 DEV10DK9.DSK    --  This is Visualgen Developer PTF2 disk 9
 DEV10DKA.DSK    --  This is Visualgen Developer PTF2 disk 10
 
These files are disk images of the diskettes.  They are in
SAVEDSKF format and must be loaded to the diskette using
LOADDSKF.
 
Here is an example of the LOADDSKF command.  The following
example will create the installation diskette.
LOADDSKF d:\DEV10INS.DSK A: /F
 
Please note that the diskettes you use will be formatted and then
overwritten.  Any data that was previously there will be destroyed.
Do NOT use any diskettes for this process that have valuable data on
them.
 
 
The Installation Utility uses the information in the service package
files to UPDATE VisualGen Developer.  This is a product update to
an existing product, it is not a new product install.
 
To update VisualGen Developer complete the following steps on your
your workstation:
 
    1. Close VisualGen and its associated facilities.
 
 
    2. For VisualGen Developer, do the following on the Installation
       and Maintenance window:
 
         a) Insert the Install diskette into the A drive.
         b) Enter:     A:\INSTALL
         c) Select Continue from the main logo.
         d) Select 'Update the currently installed product' from the next panel.
 
 
    3. On the Update window:
 
         a) Select Save a backup version to store a backup of this
            level if you wish to.
         b) Select Update CONFIG.SYS to automatically update your
            CONFIG.SYS file if you wish to.
 
    4. Select Update.
 
       The Update - progress window displays, and the update
       operation begins.  Insert the appropriate diskette when
       prompted.  When the update operation completes, the Update
       window closes, and a message displays indicating that the
       update operation was successful.
 
    5. Select Ok.
 
       The Installation and Maintenance window displays.
 
    6. Close the installation utility
 
