Explanation of Error Messages for the HP Supplied Novell NetWare DOSODI 
Client Driver (HPISAODI) for HP 27247B/27252A EtherTwist PC LAN Adapter/16 
Plus Cards.

General note: HPLANSET is the test and configuration program for the
  HP 27247B and HP 27252A.

Error Messages
--------------

HP LAN: Onboard RAM error.  Run HPLANSET diagnostic.

  The adapter failed the onboard RAM test.  Cycle power and try again.  
  If the error repeats, run the card test program.  If the error still 
  persists, contact dealer.

HP LAN: The IRQ value in NET.CFG is not valid for this card.

  For the HP27247B and HP27252, IRQs 3-7, 9-12, and 15 are supported.

HP LAN: Transmit failed.  Verify cabling or run HPLANSET diagnostic.

  The card could not successfully transmit on either the AUI or built in
  connector.  Your card may not be correctly cabled to the network.
  Reboot the machine and try again.  If the error repeats, then your
  card may not be correctly connected to your network.

HP LAN: Not at I/O address or not responding.  Run support disk diagnostic.

  The driver did not find an ISA bus HP LAN card at the port address
  specified.  Check your NET.CFG file to make sure that all PORT parameters
  correspond with a valid ISA bus HP LAN adapter.  Run the adapter test 
  program from the adapter's Support Disk to find the port addresses of 
  correctly configured adapters.

