Tandberg 3820 LDR  

This driver requires Microsoft's OS/2 1.3 or a comparable
version of OS/2 with LADDR.  If you have upgraded your OS/2
operating system since Sytos Plus was installed we recommend
that you review the README and re-install Sytos Plus.

In order for Sytos Plus to access this backup device, the
following lines must appear in CONFIG.SYS, in the order
described:

   a. Your SCSI host adapter driver must already be
      installed.  The driver, identified by a .BID
      extension, will either be part of OS/2 or be installed
      in CONFIG.SYS.  If the driver is in CONFIG.SYS, the
      following DEVICE= line must appear before any of the
      other device drivers:
         DEVICE=C:\[pathname]\*.BID.

   b. The Sytos Plus device driver (with a .VSD extension)
      for your device must be installed next:
         DEVICE=C:\SYPLUS\SYFILES\TBL_525B.VSD.

   c. The tape drive driver must be installed last, and must
      appear only once:
         DEVICE=C:\OS2\SUPPORT\TAPE.TSD

1.  Exit Sytos Plus.

2.  Modify CONFIG.SYS to include the DEVICE= lines in
    the order described above.

3.  Shut down the system and reboot so that the change to
    CONFIG.SYS can take effect.

If you have multiple tape drives of the same type, return to
"Utilities: Backup device setup" and "Edit" the device to
set up the multiple devices.
