006
000
016
017
011
029
007
037
006
044
006
051
003
056
The Swiftcalc Installation program creates a working copy of Swiftcalc on
your hard drive or onto floppy disks.

If you are installing onto floppies for the first time, you should already
have formatted two, 5 1/4-inch disks labeled PROGRAM and DATA.    


This Installation program will save the sample data files onto your SC
DATA disk, if you are installing onto floppies. Otherwise, the sample data
will be found in sub-directory \SC\DATA\.

One of the sample data files is called README. README contains additional
information about Swiftcalc. 

Before proceeding, please read the section in your manual pertaining to
installation.
****
The Installation program will take files from the Timeworks disks in the
SOURCE drive and transfer them onto your working copies of SC in the TARGET 
drive. 

Hard drive systems: Your hard drive should be the TARGET drive.

Single floppy drive systems: The SOURCE and TARGET drive should be A. 

Double floppy drive systems: The SOURCE drive should be A and the TARGET
drive should be B. When you run Swiftcalc, the program disk should be
placed in Drive A with the DATA disk in Drive B.
****
If you are going to install SC onto a hard drive, highlight Hard. If you
are installing onto floppy disks, highlight Floppy. When you have made your 
selection, press the F10 key.

If you are installing onto floppies, this Installation program will save
sample data files onto your SC DATA disk. Otherwise, the sample data will
be found in a sub-directory \SC\DATA\.
****
1. Select Install Swiftcalc and press F10.

2. Select Install Printer and press F10.

3. When you have finished installing Swiftcalc and your printer, select
   Exit to DOS and press F10.
****
A list of printers will be displayed on the screen. Use the up
and down arrow keys to highlight your printer or a printer compatible
with yours. If your printer or a compatible printer is not listed,
highlight Generic.

After you make a selection, press the F10 key.
****
A list of display card configurations will be displayed on the screen. Use
the up and down arrow keys to highlight your systems display configuration
and press F10.        
****


