-- Default finish parameter file for ToolMaker Version 5.5
-- Generic copymill information
set TOL 0.03
set IN_MM INCH
set TOO_RAD 0.25
set COR_RAD
set TOO_AXIS ( 0.000 0.000 1.000 )
set Q_FLAG false
set OUT_FILE FTEST.TPF
set IN_FILE TMP.PDB
set MTL_THK 0.000
set CTR_TIP TIPS

set ENABLE_ANALYSIS false
set ANALYSIS_NOR false
set ANALYSIS_CRV false
set SPINDLE_SPEED 3000
set PROG_NUM 1234
set START_SEQ 1
set INC_SEQ 1
set TOOL_NUMBER 1
set DIA_OFF 0
set LENGHT_OFF 1
--Cimsurf setup information
surf FROM 0.000 0.000 1.000
surf CSR Z 1.000
surf FSR Z .750
surf FED 20.000 20.000

-- Copymill finish cutting information
set ENABLE_FINISH true
set SEC_AXIS ( 0.866 0.500 0.000 )
set INCR_BY .100
-- Copymill rough cutting information
-- Stitcher information
set STITCH_ZIG true
set ADVANCE ( 0.000 0.000 1.000 )
set CLFILE_NAME TMP.CL
set ADD_FROM true
set RET_FROM true
set DIR_CUT FORWARD
set DIR_STEP FORWARD
set ENABLE_CLIMB false
set FINISH_USE_FSR false
set FINISH_USE_CSR false
set FINISH_NO_LIFT true
set CLDIS 0.100
set FDDIS 0.100
set FRDIS 0.100
set STITCH_RAMP false

stitchop define-lift K_lift (
set USE_FEED_PLANE false ;
set USE_CLEAR_PLANE false ;
set SUPPRESS_LIFT true ;
set INCR_RAPID_DIS 0.100 ;
set INCR_FEED_DESC 0.100 ;
set INCR_FEED_RETR 0.100 ;
stch-cmd STITCH_RAMP false ;
)
stitchop define-range K_range (
)
stitchop define-ctxt ctxt-section (
stch-cmd STITCH_ZIG true ;
)
stitchop define-rules K_rules (
assign-lift K%d K_lift ctxt-section ;
)
stitchop define-filter K_filter (
assign-range K%d K_range ;
)
stitchop intersect-filters all-filters (
include-filter K_filter ;
)
stitchop define-order Order (
assign-order K%d FWD K_rules ;
)
