				 !!!! IMPORTANT !!!!


  Terminator 2029 has certain MINIMUM requirements in order to run 
  on your machine.
  Your machine must have the following:

  Hard drive with at least 14 Megabytes free disk space
  585K free RAM (599040 bytes free if using CHKDSK utility)
  1 Megabyte of EXPANDED (EMS) memory

  NOTE: ALL COMMANDS THAT ARE TO BE TYPED INTO YOUR MACHINE ARE ENCLOSED IN
  SINGLE QUOTATIONS OR ARE SEPARATED FROM THE REST OF THE TEXT.
  Example:
	If we want you to bring up a directory listing of your hard disk, it
	will be written in this text as,
	Please type 'DIR' at your command prompt
	or,
	Please type in:
			DIR
	at your command prompt.

  If you are uncertain as to whether your machine meets these requirements, 
  check your DOS manual to find out the correct commands. If you are using 
  DOS 5.0, you can type in 'MEM' at the command prompt.

  To get 1 Megabyte of EXPANDED memory, it will be necessary for you to use a
  memory manager. Without a memory manager, your machine has only EXTENDED
  memory. Terminator 2029 will NOT work with EXTENDED memory. Call your local
  computer software dealer to have a memory manager recommended to you.
  They can also aid you with configuring your system properly. 
  The Terminator 2029 has been tested and works with:

  EMM386
  386MAX
  QEMM 386

  In addition, if you are using SMARTDRV.SYS, we recommend that you 
  remove it from your AUTOEXEC.BAT file prior to playing the game. 
  Because smartdrv.sys has the ability to cache reads and writes to 
  and from disk, we have found that it can cause intermittent problems.

  To install The Terminator 2029:
  1) Put the install disk into your floppy drive.
  2) Access the floppy drive by typing in its drive 
     letter followed by a colon at the
     command prompt.
	Example:
	If the disk is in drive A you would type at the command prompt:
	A:
	then you would hit enter.
  3) Type in the word:
			INSTALL
     then hit enter.
  4) Follow the on screen prompts to install the game.

  
Troubleshooting:

  If you are experiencing technical difficulties, it is important you check 
  the following BEFORE calling our tech support staff.

  1) Check your memory. We have found that if any problems occur with the game,
     they usually arise from lack of memory. Consult your DOS manual on how to
     determine how much memory your system has.

  2) Check to make sure you have run SETUP, and that the configuration you
     selected is supported by your machine.

  3) Run the DIAGNOSE.COM program supplied on DISK 1 of 
     The Terminator 2029 disk set. This will analyze your system and
     inform you of any problems regarding compatibility with the game.
     The DIAGNOSE.COM program does not get copied onto your hard disk
     so you must run it off of DISK 1. You must be on the drive where
     you will install the game, or where the game is already installed.
     Then type:

	A:DIAGNOSE


  If you still cannot seem to get the game working after trying the above, 
  call us with pencil and paper ready, and please be next to your machine.
  You will be asked to provide the following information:

  1) What type of machine. (286, 386, etc)
  2) Brand of machine.
  3) Total memory on hard disk.
  4) Total free RAM shown when CHKDSK utility is used.
  5) Total amount of EMS memory present.
  6) Display type.
  7) Memory manager type.
  8) Setup options selected.
