Microsoft QuickC and QuickAssembler Version 2.51 Main Setup Program

Note that SETUP.EXE cannot be run from the C: Harddrive. You must
copy the files in DISK1, DISK2, & DISK3 to (3) 1.44Mb Floppys. 
As this program originally was on (9) 5.25" Floppys, when Setup asks
for a new disk, just press 'Enter' to continue on the same Floppy. 
Then, when SETUP.EXE gives same error bottom status line, switch disk.
There are about three (3) 5.25" Floppy Disks worth on each 3.5" Floppy.

C:\QC2\BIN\NEW-VARS.BAT
This is a sample AUTOEXEC.BAT file that sets environment variables for
use by the QuickC (R) and QuickAssembler (R) Version 2.51 Compilers. 
This file can be used to set up an environment for running the 
compilers, or it can be merged with an existing AUTOEXEC.BAT file. 
For OS2 Real Mode or DOS only.

C:\QC2\BIN\NEW-CONF.SYS
This is a sample file with commands that should be copied into your
CONFIG.SYS file. If these commands are already in your CONFIG.SYS file,
then you should use values at least as large as those in the sample
file. This file is for DOS only. 

MOUSE.COM has been placed in C:\QC2\BIN. To install the mouse driver
provided with QuickC/QuickAssembler, the command 'MOUSE' must be
executed from AUTOEXEC.BAT or before using QuickC/QuickAssembler.
MOUSE.COM should be used instead of MOUSE.SYS that used to be provided
with older versions of Microsoft products.
